3 Channel Amp - 1 power supply?


I'm considering the purchase of a 3 channel amp, since the center channel
handles most of the workload when playing a dvd movie, I was thinking
it would it be better to try and find an amp that has only one power supply
for all three channels.
My thought is since the center channel is doing most of the work,
it would utilize the majority of the power while the L&R speakers
can draw power as needed - make any sense?

Or...

Find a 3 channel amp that has a separate power supply for each of the
three channels?

Any amplifier recommendations for either scenario would be greatly
appreciated.

Thank You
sedona
I use a three channel amp, except mine drives my center and rears. Mine is of the same brand as my two channel amp so this works fine for me...single power supply (1kva).

If different brand of amps are used I would think that the three channel amp should drive the center and fronts with the odd man for the rears.

The center may get more work load as you suggest but I'm not sure that it's work load requires the greater power draw on an instant demand basis...I may be wrong.

Dave
In order to give you good advise, we would have to know what the rest of your system is comprised of.
The speakers will be a pair of Eminent Technology LFT-VIIIa's
(ET VI's?) with the LFT-12 center channel - Nordost SuperFlatLine
MKII cables - a/v processor still to be chosen.

Thanks in advance
Based on your system, I think you should instead focus on how much power you will need to adequately drive your ET LFT's. I vaguely recall that they are not terribly efficient (84-85 db?), so they will need a fair amount of juice to play at high volume levels. While it's true that the center channel carries most of the dialogue, it does not normally handle low frequencies (many center speakers cut off at 80-100 Hz).

You have correctly noted that there are two schools of thought on power supplies for multi-channel amps: one large supply for all channels, or separate smaller supplies for each channel. Both design approaches have proven to work well, assuming the manufacturer executes the design properly.

I am personally of the persuasion that separate power supplies provide somewhat better sound quality, and therefore I use a Bryston 5B-ST (150 wpc, 3-channel) amp for the center speaker and rear surrounds, and the more powerful Bryston 4B-ST (275 wpc, 2-channel) amp for the main speakers (which have flat frequency response down to about 26 Hz).

For home theater use, I think Bryston makes a nearly unbeatable line of stereo and multi-channel amps (and a very fine pre/pro). And if you also use your system to listen to music, then the Bryston amps are a particularly good choice for dual duties.