6h30 tubes dampers to replace Audio Research ones

Tried both the stock ARC and Herbies. If you haven’t tried the Herbies they’re better. As far as placement I always preferred them close to the top as you can get them. I found farther down you go you lose the magic.

+1

Not only that, but all (rpt all) other Tube dampers hurt the sound 🤕, including but not limited to silicon rings, ebony dampers, brass dampers, Swiss Ensemble woven copper sleeves, Tube Socks, and Tube Coolers (metal fins). Almost all dampers really are perfect examples of expectation bias in action.

I have a small drawer full of tube dampers and have pretty much tried them all.

My favorite is the EAT Cool Damper.  Unfortunately, they are big enough, (and kinda expensive) that the use in some gear is limited.  The ones I use the most are the Herbie Tube dampers.  GREAT tweek for the money.

I agree that "some" tube equipment sounds better without damping, but for the majority of gear that I have owned, (which is a LOT), I like what the dampers do.

If the OP would like, I think I have a few of the ARC dampers that I have never used.  Pretty sure they are clear, not black.  I would be more that happy to send him a few for free.

IMHO, they are one of my least favorite tube dampers.

Thank you very much for all your answers, very nice.
what i dont want is to move the needle to a clearer sound losing warmth..... But make a fuller sound could be good.....
So time to vote :
1- Leave the black ARC ones in the cd7 and put Herbie’s in the ref 110
2- Leave the black ARC ones in the cd7 and put ARC ones (given kindly by mofimadness) in the ref 110
3- Move the black ones from cd7 to ref110 snd put Herbie’s in the cd7

i thank you all 

It is of utmost importance that you source the rings from Audio Research.
The right rings for the right mode/vintage of your amp.  Some were transparent silicon recent ones are made of cryogenically treated and quantum enhanced black diamond amorphous material with precisely calculated heat conductivity.
You must slide them in top down and seat them right at 1/2mm above center of gravity of that particular specimen.
Best of luck.