... abit confused: how does a power cord affect the presentation of sound...


Hello to all...

I was shifting around components in my system, trying to squeeze out better controlled bass, more definition within the soundstage, and better define the "voice/midrange" presentation...

I presently have a tube preamp (hardwired with a wall wart) into an HT Receiver; source is a Marantz SA-8001 CD Player

Swapped out a Yamaha HTR -5550 (hardwired) for a Parasound HCA-750A (which needs a power cord).

CD Player is powered with a PS Audio Statement SC power cord, so I went in my closet and pulled out another PS AUDIO Statement SC power cord, hooked it up and expect to give it at least 5 days continuous re-break-in before serious listening.

Took a minute to lookup reviews about this power cord - and I read some rather confusing reviews: some luved 'um, some liked 'um, but some thought them " ...slow... " (?), and giving a veiled presentation...

I'm gonna listen and decide myself - but I'm abit confused: how does a power cord affect the presentation of sound - I know that interconnects and speaker cables would/could/Do affect sound presentation - but how could a power cord?

Explanation/thoughts please...
insearchofprat
>Measurements do not tell the whole story. Play A note with a cheap >violin the meter will show 440Hz. Play the same note with a Stradivarius >the same meter will also show 440Hz.
>Verdict? Trust you ears.

The dominant frequency of both will be 440hz but the spectrum of frequencies will be totally different and absolutely measureable.
If a power filter is required (and it does!) buy a power filter.
It cost 1/5 of one of those fancy power cords, but filters much more than 5x a cable.
Any addition of an active electronic component, never mind how small, will add to the noise level... :) At least a cord add not a noise of his own being passive....Engineering is the art of trade-off...There is always a cost to pay if someone add an electronic component to the gear or to the system....What i say is about active filter, but passive filter is perhaps a good idea... I prefer my minerals and stones.... :)

Yes, i use passive minerals to filter my grid.... With success at peanuts costs...

I will not argue further because adult brain are opinionated and my goal was reach, hi-fi at low cost, and with only non orthodox homemade methods... I succeed... :)

If i had confidence only in measurements the cost to improve would have been way higher.... Happily i trust only my ears and play with the 3 dimensional embeddings of my audio system with my ears experiments guidance only... :)

« Dont ask if it is possible, create it» - Groucho Marx

« It dont take genius, it takes only time» -Harpo Marx
b4icu,
I have already said. Trust your ears. Measurements do not tell the whole story.
also...
please don’t get technical. I can’t help with that.
Interesting about the Stradivarius. Read about a test they did with master violinists who picked the new violins as the best sounding over the Stradivarius when they didn’t know which one was playing. Trust your ears not your eyes.

https://www.livescience.com/44651-new-violins-beat-stradivarius.html