Active crossover advice for 1000hz biamp

Marchand can custom made one for you......is it not too high for crossover point the 1k-1.2k?

Well, I had in mind two cut options. One was around 700hz just above the cut off of the horn(the compression driver only goes down to 500hz) and the other around 1100hz. I rather prefer the 1100hz since I think the 700 is too critical area to cut but I can try.
Alan

Hey, how about a balanced Marchand along with a Manley Massive Passive EQ. Only another $5K, but all analog.

Alan, in order to do this correctly, you need to match amplitude levels, bring acoustic centres pretty close and, of course, choose the optimum xover frequency and, not least, the best acoustic xover slope... a few other things perhaps, but the above are really necessary.

So, can you find / buy an inexpensive tool ($¬200) in the form of a Behringer deq or their dsp? OK, it's audiophile non-approved BUT you can use it to determine all the optimal parametres of yr system. Once you know that, go ahead & buy the best xover. At least you'll know what to do with it!

Thanks Greg.
Thats a very good advice I will do it. I was checking
and you are talking about the behringer DCX, its the digital crossover. I was also reading and doesn't have so many bad comments. A lot of people is using them in their setups with little degradation and there is and upgrade path of the analog outputs!!!
Maybe I will stay with the DCX for a long time, for what I understand its lack of hi end is balanced on the other side with the tools you have to shape the sound on real time.
At the end like in everything in life there is no free lunch.
Thanks
Alan