Am I wasting money on the theory of Bi-amping?

As a long time audiophile I'm finally able to bi-amp my setup. I'm using two identical amps in a vertical bi-amp configuration. 

Now me not fully understanding all of the ins/outs of internal speaker crossovers and what not. I've read quite a few people tell me that bi-amping like I'm doing whether it's vertical or horizontal bi-amping is a waste since there's really not a improvement because of how speaker manufacturers design the internal crossovers. 

Can anyone explain to a third grader how it's beneficial or if the naysayers are correct in the statement?



No I don't bi-wire, there is nothing to bi-wire.  All speakers cables are the same 10ga.  All the interconnects are the same Audience OHNO single crystal developed by Dr. Ohno.

My rig is somewhat easy to understand...just think of it as regular old rig until you get to the x-over, then its like three stereos all playing the same music (in different frequency ranges). Simple.



Multi-amping could have advantages even if done before the cross-overs, and even more so if each channel has its own power supply.

If a speaker has a challenging impedance / phase angle above or below the frequency range of the cross-over the amplifier will often run with more strain and corresponding deviation from ideal performance at these points. A single amplifier channels performance can be dragged down across the entire frequency range by these demands, where as multi - amplified frequency ranges will only be compromised at the particular point of the challenging load, freeing up the other ranges to be powered more optimally. This might be especially true in cases of so called Class A/AB amps where more of the more optimum purported Class A bias will be allowed to run longer before resorting to the less optimum purported Class AB or Class B (these classifications are somewhat nebulous, but the results are somewhat the same).

That these challenging impedance / phase angle loads are more typically found in the bass region where the power needs are greater but where our hearing is usually less sensitive, so meeting the power demands might be more important than ultimate fidelity. On the other hand the power demands of higher frequencies ranges are typically less, but our hearing is usually more critical, and the greater purity of amplification is appreciated more.

Bi-amping is not a "theory" neither are bi-(or tri)wiring. You just need to know what you are doing. Results will depend on the quality of the involved components and als the chief`s skill-level.


Some speakers has terrible passive filters, like the famous old Infinity Kappa 9. Bi-amping won`t solve this, but bypassing the passive filters and instead using an active filter would do. 

If one were to bi-amp with a tube amp for the tweeters and mids, and a SS amp for the woofers, how does one volume match the signals since these are different amps with different gain?  Even if the same wattage the two amps might not be matched?  Thanks. 

I had A pair of speakers that responded well to a krell kav300il on top but needed more juice for the bass. In that case horizontal biamp made sense. Starting from scratch I think I’m getting great sound with a pair of matching monoblocks 1 per channel and if you get powerful enough amps you should hear what the speaker designer intended. My current system Kef Blades has a fairly bumpy resistance so the Mac Mc611’s really get it done. The speaker amp combo can make or break your system.