What piece of equipment are you looking to rewire? If you’re not sure what wire to use, do you feel confident to solder and rewire equipment? In the past for real short leads such as from a board to rca jacks on the rear panel I used to use Wonder Wire I purchased from Michael Percy. For longer runs I found Kimber Kable varistrand to work well… a lot of places sell this and probably buy direct from Kimber too.
Amp Internal Wire
Hi Gents, has anyone have any experience with upgrading amp or preamp internal signal wire? Most older equipment seems to have thin maybe sometimes poor internal wiring. In the world of OFC/OCC/Sterling and even more exotic wire available these days, any experiments done using this internally on components swapping out the cheap?
Lots of discussion about doing this with speakers, but never with components I've seen. For instance, I am thinking about replacing copper 'appliance' wire in an old Bryston with 14awg sterling from the board to the speaker binding post board.
Any thoughts?
- ...
- 86 posts total
- 86 posts total