Amp — Leave on or turn off


I always turned my Benchmark AHB2 amp off after use every night. After all, why is there an on off switch on the front panel if not to do that? Last night I accidentally left it on. This morning, when I played my first record, I couldn’t believe my ears. The same record I played last night sounded infinitely better. I tried a second record and that, too, was much better.
I know there’s a debate on the question of leaving an amp on all the time.
I now know where I stand!

128x128rvpiano

Being environmentally responsible is out of favour. So leave it on all the time if you don't care about the planet like most everyone else.

@ emergingsoul, I care about the planet, and your comment is nothing but nonsense, and personal attack on the folks on this thread. Go away, please!

+1 @charliee  Few of his posts make any sense, and he’s nothing if not consistent which is why I no longer read any of his inane threads. My amp runs at 80 Watts at idle, which doesn’t kill the environment. All my lawn care equipment runs on batteries and all my vehicles are ULEV so pretty sure my environmental footprint is smaller than most even with leaving my amp on.

The Linear Tube Audio MicroZOTL preamp has a standby mode and is powered 24/7. LTA said it’s fine to leave it fully powered up (on) 24/7 due to the low voltage to the tubes in their circuitry 

Post removed