2. amps-preamps
  3. 150386-121759

AMP or Preamp

What to add next to my system, budget $5000 to $7000?  My current system consist of Wilson Sasha speakers, Yamaha RX-A3050 receiver that I run pure direct, Rotel RB-1590 2x350 amp, Hegel DAC and a Bluesound Vault 2i streamer.  I have been looking at a Mcintosh C2600 to replace the Yamaha receiver to give me the option of adding a turn table at a later date or would adding mono blocks give me the most bang for the bucks or other options?   


nobnewob
dmbwire
44 posts
 
McIntosh C47 pre
McIntosh MC-312

ENJOY!!!
alfa100's avatar
alfa100
221 posts
 
Definitely upgrade amplifier before anything else. You need a high current amplifier cos the Sasha’s impedance dips very low around 80 Hz.  I stand corrected on 80 Hz. 
nobnewob OP
9 posts
 
Lots of good suggestions.  Going to take some time digging into all this.
caphill
674 posts
 
Upgrade the preamp first. Get the one that is better than the built-in preamp section of your Yamaha receiver. I think your Hegel DAC is probably good not sure I haven’t heard it before. Hegel generally makes good products. If you plan on keep using the Hegel DAC with a Bluesound Note streamer I suggest you look for a pure analog linestage preamp (no DAC). The McIntosh MC2600 preamp has built-in DAC.

Your Rotel RB-1590 power amp is pretty good, and especially for its MSRP of $3k it is really good. I’ve heard this amp before driving the B&W 803 D3 speakers and was very satisfying. Also got plenty of power reserve on tap to drive just about power hungry speakers out there. It drove those B&W 803 D3 with ease and effortlessly. Of course there’s always room for improvements especially to pair with your Wilson Sasha speakers. But for now I would focus on upgrading your preamp and upstream electronics first before the power amp. 
vegasears
1,173 posts
 
I'd go with the Mcintosh C2600, outstanding across the board.  Then match an amp to the C2600.
More to discover