You should obtain good results with your Classe to a point, i.e. there will be a volume above which the sound will harden as you push the Classe above its current produsing capabilities. Depending on the size of your room, this may not be a concern. The only way to go above that volume, if you need it, will be to trade up for amore powerful amp with the Thiels, preferably an amp that doubles its output as the impedance of the speaker load is halved. This is required due to the low dips in impedance at some frequencies with the Thiels. But the 2.2s are great speakers. Levinson, Krell, Rowland are three I can think of that will supply the needed current if you need to play them louder and with less harshness and better bass than with the CA100.
Amps for Thiel CS 2.2
Hi, i've
SOURCE: SONY X 5000
|
audioquest viper(RCA)
|
PRE: BAT VK3
|
audioquest viper(XLR)
|
POW: CLASSE CA100
|
MIT T2
|
SPK: JBL 4425
i start my instrument with 4425.
At first it sounds metalic high
and loosy bass. After one years
fight, i think it's under my control^ ^'
My taste is ATC, JBL.. etc. But
i wanna experience wide range
modern sound. But i suffered
from hysteric high, i really
worry'bout it. Does my Bat &
Classe will do my wish? ^ ^'
SOURCE: SONY X 5000
|
audioquest viper(RCA)
|
PRE: BAT VK3
|
audioquest viper(XLR)
|
POW: CLASSE CA100
|
MIT T2
|
SPK: JBL 4425
i start my instrument with 4425.
At first it sounds metalic high
and loosy bass. After one years
fight, i think it's under my control^ ^'
My taste is ATC, JBL.. etc. But
i wanna experience wide range
modern sound. But i suffered
from hysteric high, i really
worry'bout it. Does my Bat &
Classe will do my wish? ^ ^'
- ...
- 4 posts total
- 4 posts total