Anyone try the replica B-60 Fidelity Research VTA?

I emphasize that this is an empiric reasoning on my part. I have not proven it.

Talking about being pragmatic :)
Thanks Lew, I get it, well let's see if I can fish one replica
Or get a better job where I can spend whatever I want on audio

mulveling, I was not able to find expression ''gnarly'' in my English
dictionary but assume that you mean ''worn out srews''. Those which
function is to fasten the arm on the collar can be bought as separates.  Also with the right Allen key. The original FR screws have
an plastic piece on their ''nose'' to prefent damage on the aluminum
skale or steel parts. I made those myself and glued on the screws
''nose''. I hope you will be able to fasten your ''old B-60'' firmly this
way. 

For those with the Ikeda base, on the inside of the threaded shaft there is a slot with a pin that rides within that. Does your pin travel the entire length of the slot while using the adjuster knob? Mine goes all the way to the bottom but then only about halfway up the slot. I notice the Ikeda spec says 10mm of adjustment. I don’t think I’m getting that but I’ll measure tonight to be sure. 

I'll get the original Ikeda base in January, hopefully. 
So I can check then. 

I figured it out. If you don’t have the set screws that pinch the tonearm stalk all the way in the adjuster stops. Thought I had them in far enough but didn’t. The first thing I noticed with this part is WHY would you put the set screws in a location where they can hit the adjuster? Also, it’s tight getting a wrench in there and depending on the positioning your set screws they can be covered up which means you have to lower the adjuster to even be able to remove your arm. Oddly, if you look at various pictures of the Ikeda online the set screws don’t seem to always be in the exact same location.