@mulveling I Just now checked out your system. Very nice 👍. I too had the Ref 5SE. Bought that used. Sold it for the brand new Ref 6 last year from my ARC dealer. And had it upgraded to the Ref 6SE. Got it back in June. And yes. It took about 2 weeks. Did u have your 6 upgraded or u bought it new ?
- 28 posts total
@agbrace definitely not normal. Call ARC and explain it to them. If u do send it expect a long wait But they will tell you to ship it when they will be getting close for your repair so at least you will still be able to use your system If you want to.
Yep, I switched from the Hegel to another amp that I have, a Benchmark AHB2, which has an input impedance of 50k ohms and the chime was still audible but very much reduced such that one would not consider it an issue. Speakers are Harbeth 40.3XD ~86 dB Thanks for all the discussion and advice on this issue.
If it only chimes when getting out of zero volume, then I would try to set the volume to last used in the menu and before putting it in standby just lower it to 1. If my memory serves, it’s possible thru the set up menu.
Secondly, the Ref 6 has 15db of gain and you’re not only mismatching impedance with the Hegel amp but also, due to the high gain of the amp you’re limiting the usable volume range. It must be pretty narrow and each step increases or decreases the volume by a lot. Not a good setup.
Few other things that come to mind - make sure the Ref 6 has plenty of space around it. Place it on the top shelf if you haven’t yet with nothing above it. Allow it breathe. Are you using the rubber tube rings? If not, you should. Is it plugged into a power conditioner? Try it with the conditioner and direct to wall and see if any change in noise.
- 28 posts total