2. amps-preamps
  3. 169326-164348

Are all amps being built wrong?

The power amplifiers that drive our loudspeakers are mostly built as a low impedance voltage source. They have always been ... but why?

Loudspeakers have a (greatly) varying impedance over the frequency range. A current drive amplifier would eliminate the issues that stem from this varying impedance, and at the same time make discussions about esoteric speaker cables that strive for optimal R, C, L superfluous. Although there still would be these un-measurable ’this (very expensive) cable sounds better’ debates and opinions ... and that’s OK, that’s part of the fun. :)

So ... why are amplifiers not built as a high impedance current source?

This is an interesting read: https://www.current-drive.info/
rudyb
holmz's avatar
holmz
2,328 posts
 
It is proportional to current.
Just they shove it across a resistor and use voltage amplification from the microphone.

On the output side. the driver is not very linear to current.@rudy It was all cool into the cable impedence was mentioned. 
audioman58's avatar
audioman58
4,220 posts
 
If it sounds good that’s all that counts. Coda was a pioneer in high current and still do ,120 amps on tap short term , huge regulated power supplies doubling down in power as the impedance drops with a very low noise potted 3 KVA transformer ,not many out there can match this especially at any decent price range ,
made-in USA  10 year warranty and very competitive with anything 
In its price class and above.
andrewkelley
276 posts
 
What about the Magtech…

http://sanderssoundsystems.com/products/amplifiers/magtech-amp
gs5556
1,239 posts
 
The answer is economics. Amplifiers are voltage sources and practically all speakers are designed around being powered by a low impedance voltage source. Change the output impedance of an amplifier and then it sounds better with some speakers and worse with others. The industry is not going to get together and do an Avalon-Spectral-MIT marriage of specification. The ones making current source amplifiers are mostly the ones making active speakers. In short, to optimize a current source amp you must convince the speaker maker to tailor his specs to your amp. Not gonna happen. 
jtgofish's avatar
jtgofish
515 posts
 
Audioman and andrewkelly I believe you are confusing voltage drive amps that have high current delivery capability with current drive amplifiers.The two types are more like opposites.The first type can drive low impedance loads and tend to have high damping factors and low output impedance whereas a current drive amplifier will suit higher impedance speakers [8-16 ohm] and will have a lowish damping factor and highish output impedance.
More to discover