ASR Basis Exclusive/Vector 4 combo - balanced?

Dre, many thanks for your very detailed response. Most helpful. Did you find this generated less noise than the RCA connection of your phono stage or was balanced the only option for it? Also were there any obvious sonic benefit for you in going the balanced route?

.

I did not notice any noise reduction.
- My phonostage can be switched from one input mode to the other on the fly. I turned the system all the way up and listened to the system gain noise on the balanced input mode then switched to single-end mode and noticed no change in noise level. This s most likely due to having a good input grounding scheme and/or little RFI/EMI around my table and phonostage. This method did use the same XLR input since the circuit is switched independent of the connector used.

The sonic benefit is audible in this case.
-Ayre (and ASR) claim that the phonostage works better using the balanced input. Using “Julsang” from the ATR Master Cut pressing of the Proprius LP (Cantate Domino) as a test this evening, I checked the sonic benefit in real time. In my situation, the gain is refinement, depth of stage, and a more whole sonic picture. In contrast, in single ended mode, there is a shade less of the items mentioned above. At the end of the day, I’m still happy I made the connector change. I’ve also made a pair of XLR to RCA adaptors to use with other phonostages that cross my path from time to time.

From what I’ve read about your ASR Basis Exclusive, I would expect that your may hear similar benefits.

Hope this helps,
Dre

Dre, thanks once again for taking the time to listen so that you could give such a clear comparison between the two terminations. The noise level comparisons, given the way the Basis PSTT phono cable is terminated should be as you have stated with the XLR termination but good to have the confirmation.

Your discussion re the sonic differences between the two connections is interesting and your observations with your Ayre do correspond with what ASR say about their unit; that ultimate performance comes via the balanced connections.

I'll give it a go. At worst I guess the XLR's will sound identical to the RCA's. Many thanks once again.

.

Not that it is crucial by any means, but once you make the change both your cartridge signals will have similar connection points and the same amount of metal to transverse at the phonostage input. The sonic benefit is debatable of course.

If you don't mind, I'd like to hear from you when you make the change. You can do it on this thread or via e-mail contact. It's always good to get feedback.

Thanks,
Dre

.

In the above post I should have said traverse instead of transverse. sorry.

Dre