Best KT88s (specifically for VAC Auricle Musiblocs)


I'm using a KT88 based amp for the first time - the VAC Auricle Musicblocs. I just had them serviced but one of the cheap Svetlanas blew, probably from my biasing it too high, and its been replaced by a used Genalex Gold Lion for the moment. The amps sound very good as it is, but I'd like to get the best out of them with a good matched Quad of something decent.

Ideally I would like a little more mid-range luxury and presence without sacrificing too much bass control. However lower bass is not so much of an issue because my speakers have powered subs with an active crossover (Vaughan Cabernet One).

I'm in the UK, and valve selection here is a bit limited. Nobody seems to have Svetlana Winged Cs anymore, and I've read reports of dubious quality in the later batches. Genelex Gold Lion are easy to get from good dealers who can match and measure, so that is the obvious choice. But would I be better of with some Chinese valves such as the Shuguang KT88-98? Are they going to be a bit warmer in sound to the Genelex?

I've read great reports about the Psvane KT88 T2 but they are very expensive. Also the Shuguang Treasures. The riskiest option is to buy these from Mable Audio in China, who have them up for a good price:

http://www.mableaudio.com/en/

From what I have read Kevin Hayes supplied the Auricles with the Shuguang KT88-98. These are very affordable, but I suspect that Kevin only supplies selected ones. 

I could also buy from the US, and I'd appreciate any recommendations for the best source.


andreweast
Andrew,

   I have never listened to a VAC preamp, however, my Audio Horizons preamp has plenty of gain to drive my 90 db speakers. I was buying from www.dougstubes.com my Penta SC tubes( specially selected tubes from Shuguang) which have the solid plates, but Penta apparently has raised their prices so Doug recently brought in the Ruby KT88V-STR, http://www.dougstubes.com/power-tubes/6550-kt88/ruby-kt88-v-str.html which are identical solid plates with top and side getters made by Shuguang. I haven't tried these yet but bought a quad for future use. The solid plate Shuguangs are very neutral and natural in tonal balance and timbre, neither too warm nor too cold, but tweaking the right combination of interconnects, speaker cables and power cords, helps to bring that all into focus. 


   Sherod


Tweaking is what I'm doing now. And I have to take back what I said about KT-120s since I switched to the 8 Ohm tap. Now they are neutral and dynamic rather than warm. I think the previous tubes I was using sounded too harsh and forward on the 8Ohm so I was forced to use the 4 Ohm tap. My speakers hardly drop below 8 Ohm so I guess this was overworking the amps. 

I actually want a bit of warmth back now! Oh for a 6 Ohm tap. I'll try chanigng back to Mullard driver tubes. 
I used a lot of different kt88 in my VAC integrated and found gold lion reissues to be best.