Best Tonearm and Cartridge for 4K or under for restored Garrard 301


I have a good set up for digital audio and would like to venture into analog audio. My digital set up is
Cary DMS600 -> Cary SLP05 -> Cary CAD211FE -> KEF Blade. I love the sound!

My first and only TT is a Thorens TD126 with TP16 tonearm and TMC60 MC -> PPA990 and phono stage is Cary PH302.

I bough an old Garrard 301. Planning to get it restored by Jim Campbell. Have a slate plinth. Now I am looking for a tonearm and cartridge that will justify my set up. I am thinking 4K. I could go lower or higher depending on the feedback, cost/value. I am looking for a good bargain. If I don't like it, I can easily sell it without much loss. I listen to classical, jazz, rock, indian music. 

I have never setup a tonearm before. But I looked extensively on the internet and Michael Fremer's how to set up videos. I understand all the different angles, VTA, SRA, Azimuth, Zenith. 

Looks like Michael likes Kuzma 4PT, I liked his review of the tonearm.
I am also looking at linear trackers like Transfi Terminator.
Woody, Triplaner Mk VII, SME 3012R, SME 312, Ortofon RS 309D, Dynavector DV 505/ 507, Reed 3P, Stogi reference, FR 64S, FR 64 FX, Sumiko 800.

kanchi647
I spoke with Sien regarding the SPH Bearing. He made a lot of those for Lenco and TD124 and now makes them for 301/401. 1/3 the price. I am planning to buy one from him. @noromance thanks for the lead. Anyone here have any experience with SPH bearing?
Just get the SPH. However you should listen and understand the 301 sound with the original bearing first if you can. After a few weeks, swap the bearing. It’s a 15 minute job. Leave run for 6 hours. Then listen to your reference record. Be prepared to be amazed. The same with the idler. It's a blast. 
@noromance Is the SPH same for 301 and 401 (30mm size).  Will it work with grease bearing as well? Any you-tube videos on how to change the bearing?
Thanks
The 301/401 oil bearings are interchangeable. I'd check with Sien on specific compatibility to be certain. I think he has a video but it seems to be private. The bearing is taller so keep that in mind. With the platter removed, you just need to remove 3 bolts to change the bearing. No need to overtighten. 
Just bought a Pete Riggle Woodie universal tone arm.
now have to look for a cartridge. Thinking of Denon DL103.
what’s the difference between DL103 and DL103R?
Thanks