Bi Amping: highs and lows or a seperate amp for the left and right.

bridging will decrease the load impedance twice and may become a heavy load for amp unless it has unlimited current to support that. Notably if your speakers going somewhere all the way down to 2 ohms, the load impedance per amp will be nearly 1 Ohm and unlikely there's an amp stable to load nearing short circuit.

technically I would only use vertical biamping for that particular matter.

biamping with same amps works the best as you simply doubling the power. The distribution of power is controlled by your speaker internal crossover pretty much.

Why would I bridge? And what, the amps? if bridging amps, would need 4 stereo amps then instead of 2. 

The amp is currently driving the speakers without issues, i don't think the impedance changes when splitting low/high? Just that the low will have the low impedance (typically), and the high not anymore. Vertical: one side of the amp low impedance, other side high. Horizontal: one amp only high impedance, the other only low on both channels. 

Distribution of power is determined by arranging vertical vs horizontal. In one setup the stereo amp running the highs sees very low power demand, stereo amp running the lows sees LOTS of power demand. Vs. summetrical (per amp) running 1 amp for one speaker, high channel low power, low channel high power. 

Two identical stereo amps run in a vertical bi-amp configuration (one amp on each speaker) have similar advantages as monoblocks...physical separation, no crosstalk, and a dedicated power supply for each speaker. Plus, you can run the tweeters or mids/tweeters from a channel that doesn’t have the burden of driving heavier woofers, which has some benefit too.

Two non-identical amps in a horizontal bi-amp configuration can allow you to do something like dedicating a sweet sounding smaller amp (like a tube amp) on the tweeters or mids/tweeters, and a ballsy solid stage on the bottom. You just need to be able to match levels of the amps.

You can also do a hybrid bi-amp configuration by using monoblocks on the top, and a stereo SS on the bottom.

There are pros and cons to each approach, and every situation is a bit different, so there’s really no one size fits all scenario. In my case, I had two Dynaco/VTA 70 tube amps that are wonderful in the mids and highs, but not quite as authoritative on the bottom end, so I added an integrated SS amp to drive the woofers below 80hz.

"Plus, you can run the tweeters or mids/tweeters from a channel that doesn’t have the burden of driving heavier woofers, which has some benefit too." Not in vertical. There, the amp's ONE channel is burdened, and typical stereo amps share power supply. THAT would be (to me) the only reason to run HORIZONTAL, keep the heavy lifting in one amp, and easy peasy for mid/high with the other stereo amp.

But as you stated, differences likely minor. And vertical already sees the load on each amp 'halfed', plus crosstalk/separation, etc. Would be sweet to be able to physcially place each stereo amp near the speaker to reduce long speaker wires (and run low voltage signal lines for the distance). Or?