Biamp w/2 Bryston4BST s or 1 14BSTw/B W?

I have been considering the same thing. I recently purchased the N802s and have a 250W amp which drives them pretty well, but after some discussions with my dealer I think it would be better to go with the 500W power rather than biamping dual 250W. I think the bass would benefit more from something more than 250W. Besides that, I am using the XLR connections, and my preamp doesn't have dual XLR outputs, so I'd have to get a custom Y adapter made which is also a concern - I'm not sure if that would degrade the quality of my cable connection or not - and it does change the input/output impedance between the preamp and power amp.

As Mezmo mentioned, its better to go with the 7BST or 14BST since they are designed for that power. I think in general bridging an amp raises its distortion numbers a bit so the monoblock design would be better. If you have the money, then I think your choice should be getting either the 7BST or 14BST. I think I would lean more toward the separate 7BST monoblocks, but there probably isn't much or any difference between the two 7's or one 14 - six of one or half dozen of the other...

Mezmo's second response seems on the mark. My Bryston 4b more than adequately drives my Infinity Beta Woofer columns at very high volumes and without any hint of breakup (I use a 3B for the mid/high panels). Can't imaging needing more power. So, unless you have clear evidence that your Nautilus is unusually power/current hungry, I'd go the way suggested by others and BEGIN with a single 4B to see is you need more. In my (and P. Actzel's) view, bryston is hands-down the best electronic value currently available...not even a runner up waiting nearby. Build, circuitry, and sound quality every bit as good as Krell, Levinson, or you name it but at a price that's sane.

Mcoker, I have owned my B & W N802's for about a year. I have had various amps in my home as demo units. I am currently running Krell FPB 200c to them. That amp does a respectable job, but is not enough in the long run. I considered the Bryston 4b ST's and a pair of 7b ST's. I emailed Bryston and they told me that the 7b ST's betters the 4b ST's in more ways that just power. They present a better sound stage and are definitely better than running two 4b ST's bridged mono. They concurred that you give up sound quality when you bridge the 4b ST's even though you get more power. Having tried several amps with the 802's I believe the more power the better. My goal is to eventually biamp the 802's using the Krell FPB 200c for the highs and a FPB 300c for the lows.

Bwyoung is on the right track: I owned a pair of 4B-ST's and loved them ... until I heard my system with the 7B-ST's. The trade-up was a no-brainer for me since I enjoy a well defined bottom end and my speakers are tough to drive. Overall, the sound stage and "live" experience was better with the 7B's so I would forgo the bi-amping in favor of the better amps. Hope that helps.

This seems to be a popular question, as I'm addressing the same issue and considering the same alternatives.

My conclusion is the 7B-ST, rather than the paired 4B-ST. B&W told me straight that my original choice: B&K 250wpc monoblocks, would be a respectable solution at modest listening levels. The B&K monoblocks are built to handle peak dynamic loads. However, that the next step would be to provide robust power to the LF: The speaker's impedance profile changes driver by driver, HF --> LF. My solution is then, the 7B-ST with an internal bi-wire: probably XLO.