bias Classic 60, Audio Research


DOES ANYBODY OUT THERE KNOW HOW TO SAFELY BIAS A CLASSIC 60 AUDIO RESEARCH TUBE AMPLIFIER.

BOUGHT MINE USED--LOVE IT--INSTALLED NEW TUBES--BUT THE BIAS INSTRUCTIONS SOUND DANGEROUS TO SAY THE LEAST.

ANY HELP, MUCH APPRECIATED.

THANKS.

GEORGE
128x128gmardinly
Hi,

I own the Audio Research Classic 60 and can instruct you, I believe. Do you have a meter? You will definitely need one, obviously. You will also need amp probes with an alligator clip to make it simpler. The amp will have to be turned onto the handles on its face. The resistors are actually under the PC board. Some of the resistors are hidden a bit under the chassis. It will help if you have a competent friend helping you. You may need to use standard amp probes while turning the bias pot and reading your meter ( which should be turned to read milliamps, mA ).
If you think you're ready to all do all of this let me know at autumneve@hotmail.com.

P.
ARC will fax you the info.
If you do it your self you should get probes that will clamp onto the resistor.
Then you can do one channel at time with the amp on it's side then turning onto the other side for the other channel.
Get a set of probes that have a few inches of reach and are well insulated.

nice amp

LM
I'll bet you the pink slip you don't have a meter so the best advice I can give is take it to a local shop.Which is not to say the first poster can't walk you through it,which is a nice move on his part.Good luck,were all in this together,Bob
Hi George,
It simple to do, i did several times when i had this amplifier. First of all you need matched tubes (Matched Octet tubes).
Switch Off the amplifier and unplug the 110V
Then remove the tubes cage and place the trimer in Med position
Then place the amplifier to be lying on one side
Remove the top back cover to access to the circuit board
100 Ohms resistor are located near the Power and output transformer, they are 2 W and are in black color (you should be able to find pins near this resistor for TP1, TP2, TP3 and TP4
So use Alligator clip between 2 resistors and place the DVM on Continuous Voltage, for measuring at least 200mV
Then Plug the 110V and Switch on the Amp
The DVM should start to display voltage for 10 - 20 mV at the beginning and increase at least for 30min then it should be stable (during this phase if the 65-70 mv is reached turn a the trimer a little bit to read lower than 65mv
So when it is stable, adjust the value to 65mv
Verify the other resistor they should between 5mv in general if your tubes are matched
If you provide me a email address, i should be able to send you some pictures, i did some when i used to run the procedure
I hope this helps
Laurent