2. speakers
  3. 183168-6478

Building stands for Harbeth 40.2's

I talked with my builder today. I told them I would reach out for more expert opinions on a final design.

Since the TonTragers are the benchmark for Harbeth stands, I'm trying to match them as much as possible.

Question 1- The TonTragers have a 1 inch riser in each corner of the top of the stand. Is this critical for optimal sound ? Or would it be sufficient for the speaker to sit flat on the top of the stand ?

Question 2- Obviously the top needs to be open except for the exterior frame, but can the base be a solid flat piece of wood...or should that be open also ?

Please chime in with any ideas...also I plan on using some good cone spikes on the bottom.

I've attached a pic of the TonTrager for reference for the above questions.

Thanks in advance.

krelldog
grislybutter
3,272 posts
 

@yogiboy

you are right. My apologies. What was I thinking. 

Entering my opinion about looks on an anonymous forum?

Here is a constructive angle: if you are to build stands that you will look at all day, make them pretty.

 

donvito
400 posts
 

@grislybutter

Something like this?  

  1.  
  2. 177861-166623
grislybutter
3,272 posts
 

@donvito that's what I find pleasing to look at. To each his own.

whipsaw
759 posts
 

To each his own.

But if they’re not to your liking, you felt compelled, at least in this instance, to assert that they’re "hideous"?!

😂

krelldog OP
323 posts
 

I started this thread.

For the record I think the TonTrager stands are beautiful

More to discover