Cardas Din plug compatible with Graham Phantom II?

Thanks for pointing out the obvious to me.

I think i read it somewhere here that the SME din pin configuration is reverse but not the custom Graham.

Jfrech is indeed correct regarding the din pin orientation. The Graham and SME are 180 degrees different. Not a problem with the straight din plug but could be with a 90 degree din plug depending on the space underneath the armboard/plinth.

Not a problem with the straight din plug but could be with a 90 degree din plug depending on the space underneath the armboard/plinth.

Not to put too fine a point on this scholarly discussion ;-) but the rt. angle plugs I've seen (not all by any means) have a set screw that allows the little receptacle plate to be rotated 180 in the plug body. You'll notice they don't make L and R oriented 90 degree plugs; that's when I figured out what the set screw was for!

Nsgarch -
Yes you are correct about that set screw and the ability to rotate the inner white plug - however, it is very easy when doing so to break one or more of the fine wires inside if not careful........it's a delicate operation.