Changing Magneplanar LRS jumpers for Neotech 12 AWG

Magneplanar are well-known for their panel isodynamic panels and their potential for clean sound is very high especially considering their price.  The LRS are no exception and they share a common characteristic among many Magneplanar if not all, a steel nickelled jumper. Many forums exist about this topic and the results after changing these jumpers are positive in many case or not change in other cases.

Using Neotech with Teflon 12 AWG solid core, simply propelled my LRS on another level.  I need to say that I used Mundor Connector BFA Beryllium Copper Banana Plug soldered with Cardas solder for convenience.

Imagine listening music at midnight with an excellent definition, pin point imaging a kind of pure happiness listening to music and keep this impression at 2h.30 pm 

Much more precision globally much less grain in the voices males, females, better bass,!! better bass?? Remember that many Magneplanar use series structure cross-over so tings are interdependent the bass and table cells are interrelated contrarily to parallel cells.

The difference is huge, really huge.  Your turn to try.
It is not just the jumper that contains ferrous parts: so do the binding post assembly and fuse block. Replace the stock posts with Cardas (they fit in the holes without modification), and bypass the fuse block.
You are absolutely right and I totally agree, I wanted to highlight the fact that a simple short piece of metal of lower quality replaced by a high quality wire makes a huge difference, so changing the binding posts and bypassing the fuse block should bring other levels of improvements.
i can’t take the maggie jumpers seriously. i use solid silver jumpers made by DH Labs
I replaced the jumpers with both furutech copper and silver wiring.  I really don't know if it made any improvements in performance.  After popping off the binding plate, I'm going swap out the binding posts and bypass the fuse.