Cleaning a old tonearm


Hi, A friend gave me an old Grace 727 tonearm and it is very dusty and dirty from sitting out in the open. My question is how and what should I use to clean it. I do not want to mess with dissasembleing the bearings. The dust seems to stuck to it and will need some type of cleaner. Or is this a lost cuase? Thanks in advance.
motorpsychos
If you use lighter fluid or other hydrocarbon solvent, use outdoors or w substantial ventilation AND make sure you dispose of surplus properly; i.e., not on ground out back or down the drain.
WD-40 leaves a gummy residue. I would not characterize it as a cleaning product and I would never use it on any piece of audio equipment.

Q-tips and alchohol work for me. My used TriPlanar was not only dusty when I received it, it was coated from end to end in silicone damping fluid. Yuck! (The seller failed to empty the damping trough before boxing it up - lazy or stupid, your choice!)

It took me 4-5 hours to clean it (the TP has a lot of parts, many more than a Grace) but I look on that as time well spent. I got to know the tonearm intimately before I even mounted it. That knowledge has repaid the effort it took to gain it many times over.
Dougdeacon: I recommend using the WD-40 only after the use of lighter fluid, as it is a great degrease and cleaner.My only concern is after cleaning the tonearm you could strip it of it's natural oil's. And in the near future start to pit and show some sign's of rust.I would wipe most of the WD-40 off and only leave a very light coat. But the pledge sounds great
since it is a multi purpose cleaner and that should do the trick.
Schipo, just what are these "natural oils" on tonearm parts? A possible lubrication on pivot points I can understand but I am not aware of any natural oil occurring on metal parts themselves.

For anyone concerned with providing a "protective" coating, I would suggest a dedicated automotive or metal polish or wax. Any liquid that does not evaporate away completely, like WD-40, will leave a residue that may attract dust and dirt.
Thank all of you for your help. I used q-tips diped in carb and choke cleaner made by thr Gumout corp. Also I found that pipe cleaners worked very good in tight areas. Looks like brand new almost. Bearings feel smooth with no play. Again thank you all. The other film on it besides the dust I think was nicotine as the guy I got it from is a heavy smoker. It came right off too.