Debjit I did used solid core siltech wire to replace the internAl wire of my Norh Speakers. The improvement is so huge.
Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure
Cube Audio (Poland) designs single drivers and single driver speakers.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
* Frequency response may vary and depends on room size and accompanying electronic equipment.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
----------------------------------------
Parameters (from Cube Audio):
Power: 40 W
Efficiency: 92 dB
Frequency response: 30Hz - 18kHz ( 6db)*
Dimensions: 30 x 50 x 105 cm
Weight: 40 Kg
* Frequency response may vary and depends on room size and accompanying electronic equipment.
- ...
- 1567 posts total
@ricevs i wasn’t looking for a free pair. I would really like to try it out if they aren’t exorbitantly expensive (I don’t really know what they the cost). Anyway, I could have easily hardwired the wire straight to the voice coil but didn’t do it for two reasons 1. I want to first evaluate the best wire and experiment before soldering/desoldering things. I don’t really like hit iron touching the voice coil often. 2. I have been contemplating v2 driver upgrade.
btw, I am aware of the Mundrof’s new Angelique series. I went to Partscon couple of days back to get the 15.5awg Mundrof Silver/Gold for a power supply project where I saw those. |
@jayctoy thanks for the feedback. Where do I buy the Siltech from ? Any link ? |
@ricevs check your email. |
- 1567 posts total