Does anybody have Totem Arro's and CJ tubes?

HI UMN.
I OWN THE SAME AMP AS WELL,BUT USING IT WITH MISSION 753'S.
THE SOUND IS PRETTY DAMN GOOD. RECENTLY BOUGHT THE ROGUE M 150'S MONO'S AND WANT ADVICE ON SPEAKER SELECTION TOO.
GOOD LUCK ANYHOW

i'm using them with a jolida 302a, i've also listened to them on a variety of solid state gear (this is my first tube piece) and found the sound to be different but by no means unpleasant. i do believe my jolida is not the same level of build quality of CJ equipment nor that much wattage, so I'm sure you'll be QUITE happy with your setup as-is. I do suggest totem's speaker wire (at least give it a try, at an approx. $4-5 retail a foot, it's a steal) - 2 runs to the mid driver and 1 to the tweeter should do it.

Thanks for the responses so far.

Dmoffitt: Why did you choose the single wire Tress over Totem's bi-wire cables? I now have Audioquest Type 4+ single wire and wonder how these compare.
Thanks.

I simply happened to have a 12ft length of single tress sitting around and wanted to hook them up and start listening. i much prefer the sound of it over the type-2 I had kicking around and even feel it bests CV-6 (the AQ had more bass extension but the very high end on the tress seem cleaner / less edgy). Wire is SO system dependent tho, I actually preferred the AQ cable until I modded the Jolida, so obviously your experience might vary. Ideally I think I'm going to end up buying some AQ KE-4 or a similar silver cable or the Totem bi-wire (I'm hoping to audition both shortly).

Good thread... Has anyone compared these to "higher-end" monitors such as B&W 805sig, Dynaudio S1.4, Joseph RM7si, Snell K.5mk2, Dali Helco 300 ? I have a MV60 and I'm looking for a speaker <$3K that will do it justice. I've heard the arrows but have not been able to do a side-by-side with any of the above favorites. Note I will be using it with a really good sub so the low-end is not a problem. I'm looking for the best disappearing, depth and space I can find.