Does anyone have a Schiit Yggy DAC?


I just purchased a Schiit Yggdrasil DAC that runs much hotter than any component I have ever used.  It runs so hot you cannot hold your hand on it more than 2 seconds or so.  Schiit people say this is normal and you should leave the DAC powered all the time.  Anyone else have a hot Yggy?
golferjw
@213Runnin, re the AD5791, it can be calculated from the voltage and current specifications shown in the "Power Requirements" section near the bottom of page 4 of its datasheet that each of them consumes something on the order of 125 milliwatts (0.125 watts).  The chip itself may get a bit warm, due to its small size, but of course 125 mw x 4 chips won't make much of a contribution to the temperature rise of the overall component.

Regards,
-- Al 
I have no information about the Schiit YGGY DAC running hot and suggest you call Schiit, again, and and ask them.  k4rstar12 reported above that "he owned multiple YGGY's and they were never more than slightly warm to the touch even after being on for many weeks".   I suggest you determine how hot your YGGY is actually getting so you can review its actual temperature with Schiit.

Please note that my Ayre Codex DAC also ran hot.  The Stereophile review reported "My sample of the Codex DAC got hot to the touch—about 108°—after a couple hours.  HiFiPlus reported "Almost – it runs hot to touch like an Ayre amplifier (nothing to worry about here).   Ayre reports the Ayre’s exclusive Diamond output circuit run hot and this is normal and nothing to worry about.   I kept my Ayre Codex DAC on all the time and it was hot when being played and was never a problem.   
Just measured the temp on the top plate of my Yggdrasil and mine is at 82F at its hottest in a room at 67 degrees. Sits on a shelf in an IKEA Besta unit with about 4 inches above and 3 on a side for breathing space.