Dual 701 pops fuse.


I recently bought a Dual 701 TT. Cleaned up nice but the T125mA fuse on the power supply board was blown. Put another higher rated fuse to see if it ran, yes it does. Put in a 500mA I had and played for a little while and it popped. So is the .047uF cap the culprit or could the EDS1000 motor be drawing more current than it should. I am not a techie, please keep it simple. Thanks.
128x128gary7
The fuse rating may also need to be double checked. Thinking back, some of the manuals had the fuse rating for the USA and Europe as the same. In other words, incorrect. Read the specs carefully. Again, those other sites lay most of this information out there. 
T 125mA is marked on the board & in the manual on VE.com. I did not run it very long with the higher fuse value. It is wired for 110V.