Joeinid, thanks for the thoughts. I have tried different tubes. The one 890 plays perfect but the other( using the exact same tubes) persists in its noise. When sent off for service, the issue isn't recreated on the shop table. Granted, they aren't using the same speakers for testing. Regardless, one amp is perfect, the other is not.
EAR 890 crackle and hum
Having trouble in having trouble with an EAR 890. It crackles in the super tweeter and hums in the midrange. I have two 890's. One is dead quiet. Placing the second one in the exact spot, same connections, same PC, same tubes and the noise persists. Sent off for service and no issues found. Contacted EAR and virtually no response. I run with an EAR 912 through Tannoy Kingdom Royals. The noise is present when used in single stereo or in mono block configuration. Noise is audible from 10+ feet and is a big distraction. The noise is there with volume off, on low and between songs at higher volumes. Any ideas?
- ...
- 8 posts total
I see that your speakers have a ground terminal on the rear, in addition to the high frequency and low frequency + and - terminals, with the use of the ground terminal being described as "optional." This is just a wild guess, but if by any chance you have been connecting that ground terminal to the amp chassis, or to some other point on the amp, try disconnecting it altogether. Regards, -- Al |
drpat, Not sure where you are located, but the best tech I know is Ben Jacoby in Brooklyn, NY. He was able to find/fix problems others missed. http://www.highendaudiorepair.com/ben-jacoby.html |
- 8 posts total