Ever add a Aftermarket Cord to a TV?


I would think that of all the components that could benefit from an aftermarket cord, it would be a TV. Anyone ever try this? Would like to know b4 I snip my 32XBR.
128x128justlisten
One member that I know of tried this suggestion with good results: cut off the stock AC cord within about 6" of the TV, then attach with crimp lugs or solder on your own IEC connector. Insulate the bare leads with heat shrink sleeving etc. & connect an aupgare AC cord to this "adapter". He said it worked so well that didn't even bother to hardwire it into the set.
You can hardwire power cords into TVs and VCRs but different TV and VCR models pose different accessibility problems sometimes involving cutting into the chassis or relocating internal AC connector posts. To avoid this I cut off the stock AC cord to within about 4" of the TV and VCR and installed two IEC connectors on the stock cords. I did not hard wire the power cords at first because I wanted to test the effect of different power cords. The Siltech SPO 18M Filtered power cords yielded more constrast, better color tints (especially transitional tints), more focus, and better sound. The improvement in the sound on the TV followed the same pattern of the improvement that the Siltech made on an audio system (better fundamental tones, lower noise floor, blacker background, more detail). I did not have a significantly better picture with more expensive audiophile power cords (I tested NBS Statement, and Shunyata King Cobra on a Philips TV). I expected the picture to get even better with these cords, but unfortunately this was not the case. I have not tested a power line conditioner on the TV/VCR, but I expect it would yield better results.
Best upgrade I ever made and very easy. You will see inside, TV was Made for IEC.
I just loaned an old Transparent PC to a co-worker who isn't an audiophile/HT nut for his Sony Bravia. Both he and the Wife saw the difference.