2. speakers
  3. 137391-104219

Filling speaker Stands?

I have a modest system. Continually look for ways to improve it's performance even to a slight degree. I have read many posts about improvements than can be achieved by filling the hollow spaces of some speaker stands with some type of material....sand, kitty litter, lead shot, and some others. Here are the stands I have......
https://www.sanus.com/en_US/products/speaker-stands/sf26/ 
These stands are of metal construction. There are 2 upright support tubes which are approx. 2" diameter. The stands sit on a carpet floor with spikes. On the top plates are a layer of Sorbothane and PSB Imagine B speakers sit on top of that. The 2 metal supports are attached to the base and top plate with just threaded holes about 1/4 " diameter. Pouring some type of dampening  material would definitely require a funnel.
The reason I ask this question is that, when I thump on each upright post, it rings for several seconds. A dampening fill would minimize this but would filling those posts really benefit the speaker performance to even a small degree given my modest setup? I don't know. Probably, few have experimented with this type of scenario.Thanks for any advice.



jrpnde
phomchick's avatar
phomchick
209 posts
 
If you use sand, only use stands that are welded, stands that have bases or parts that are screwed or bolted together might cause sifting in the cracks
I had some steel stands that rang like bells. I filled them with play sand from Home Depot ($6), and sealed the tubes with expanding insulating foam from a spray can to keep the sand in.

As is usual on Audiogon, this thread is full of nonsense: toxic effect on the bass, don’t fill the tubes all the way, it will kill the sound, & etc.

Post removed 
tomcarr
1,504 posts
 
I still am curious why no one mentions the use of BBs?
geoffkait's avatar
geoffkait
23,365 posts
 
phomchick
If you use sand, only use stands that are welded, stands that have bases or parts that are screwed or bolted together might cause sifting in the cracks
I had some steel stands that rang like bells. I filled them with play sand from Home Depot ($6), and sealed the tubes with expanding insulating foam from a spray can to keep the sand in.

As is usual on Audiogon, this thread is full of nonsense: toxicm effect on the bass, don’t fill the tubes all the way, it will kill the sound, & etc.

>>>>Prolly best to file that one under WHATEVER. 😬

phomchick's avatar
phomchick
209 posts
 
@geoffkait
Yes, I said I used sand, but I also said I used expanding foam (Gaps and Cracks Insulating Foam Sealant) to seal the tubes and keep the sand where I wanted it.
To add another data point, when Infinity built the IRS V speakers, they filled the midrange/tweeter wings to make certain they were non resonant. They were charging $50,000 in the mid 1980s, and could use almost any material they wanted. Did they use lead shot? BBs? Steel ball bearings? No, they used sand.

More to discover