2. amps-preamps
  3. 1320195915

First foray into separate 2-channel amp, 200wpc

Hi, I am thinking of purchasing my first powerful 2-channel amp, to use with my Yamaha RX-V1800 receiver. This is kind of an experiment, so I don't want to spend a fortune. I need to see if a powerful amp will take better control than the Yamaha of my Monitor Audio Silver 9i speakers I just picked up. I am thinking of a minimum of 200 watts/channel. I am looking at spending up to around $500. I will probably want to find something used here on Agon.

So far, I am most drawn to an Adcom GFA 5500 here on Agon, although I am aware there are many other brands in that level of amp. I am aware of Emotiva, and wonder if anybody feels a new or newish Emotiva will be better in any significant way than the 5500. This will need to be a good performer on both music and movies.

Or, since the Yamaha is fairly powerful for a receiver, is there a likelihood that the Adcom of something similar will not make a detectable improvement?

Any other suggestions? Thanks.
mtrot
rok2id's avatar
rok2id
7,859 posts
 
'They can have just as much influence on the final sound as an amp, in my experience.'

Save the phono amp, enlightened me as to how.
BTW, your statement is absolutely correct. Your point is just wrong.
imhififan's avatar
imhififan
2,174 posts
 
I'm with Loomisjohnson, the 9i is a very good speaker and also a easy load, it doesn't need a lot of power to make it sing, a good quality power amp like the parasound A23 @125W/8ohm will do. You also can fill the 9i with 20lbs+ lead shot to improve sound.
mtrot OP
804 posts
 
Imhififan,

Hmm...my Yamaha receiver I am driving them with now is rated for 130 wpc in stereo mode. The only reason I was thinking of a separate amp was that the person I bought the 9is from stated they sounded better with more power and that he had been using a McCormack amp with them. Do you think a separate amp is not going to improve much over the receiver?

Also, I filled the 9is with sand. Do you think lead shot will be noticeably better than sand?
imhififan's avatar
imhififan
2,174 posts
 
Mtrot,
If you want to experiment if the 9is will benefit with more power than 130w, you can assign two more channel from the rxv1800 to bi-amp the 9is.
To answer your questions:
1. a higher quality separate amp will improves sound,
2. fill with lead shot then add sand to fill up gaps will be the best way for mass-loading.
Hope this help
mtrot OP
804 posts
 
Imhififan,

Thanks, I am already bi-amping them with the bi-amp feature of the 1800. Using Morrow SP2 for the HF terminals, and some regular copper zip cord for the LF terminals. Mike Morrow says his cable will improve the bass quality(not quantity) if I wire the LF terminals with his wire as well as the HF terminals. Not sure if I want to spend $200-300 in order to find out!

Thanks for the tip on lead + sand.
More to discover