professorsvsu OP
George,
I found my Goldpoint and it's a 24 step SA1. If memory serves me correctly, I bought the "standard Issue" which means it's impedance is 25K ohms. I'll run the VTPH-2A through it this weekend direct line to my Bryston 4B Cubed and give an update.
A ladder attenuator configuration (the best)
https://ibb.co/kCLLKJ
A 10k ladder has a max output impedance of 2.5k, and with the 30k of the 4B that's a 1:12 ratio, pity yours 25k if it's a ladder it will be 1:6 ratio, but saying that, it maybe fine as below you see that out of 30 audiophiles only two detected something below 1:10
We conducted 30 strong audiophile group listening, level matched using 1khz test cd at the speaker within 10th of a volt, then with music.
Using an amp I made to be able to change the input impedance quickly, and my Lightspeed (a ladder) the group could not hear any difference from 1:100 ratio down to 1:10 ratio.
A couple "thought" they heard something lower than 1:10, but it wasn't till 1:3 ratio that 50% thought they heard a difference.
Cheers George