Floorstanders for $3500

I had the Super Eclipse IIs a few years ago. It literally went this way:

Received and set them up on a Tuesday.

Listed them for sale on a Wednesday.

Sold them on a Thursday.

Couldn't have been happier that was over.....

Shakey

Shakey, perhaps that is why there is a version 3. I have not heard either version. My suggestion was based on the tube friendly drive and generally favorable comments received by Coincident speakers and amps from reviewers and consumers. As they say, your mileage may vary.

Rhljazz, is your statement about my list of speakers not being tube friendly based solely on their efficiency ratings (sensitivity in db)? If so, 90-100 watts/channel is more than many tube amps & I thought sufficient.

I believe it's also important to look at impedance perhaps even more so than sensitivity given your amp's relatively generous power rating for a tube amp. For example, the Revels drop below 4 Ohms at two different parts of the frequency spectrum (NRC measurements) despite having a stated nominal impedance of 8 Ohms. I'm no audio engineer by any stretch, but I'd think that could potentially be a bit of a tough load for a tube amp or even many solid state designs. I'm sure your amp could drive them, but it might not let you get the Revels to fully open up or perform at their best. That's one reason I recommended the Joseph Audios above as I don't think they drop below 6 Ohms. Anyway, maybe just something to consider.

47ghibli, it's not only efficiency but also an impedance that does not vary all over the place. Tube amps for the most part will have an easier time driving a load above 8 ohms with a 6 ohm minimum. That's not to say a 4 ohm speaker won't perform well if using the 4 ohm tap from the amp but you still don't want a dip to 2 ohms in the power regions.

Ralph from Atmashere posts all the time about this. His website has some valuable info you should read.