2. vintage
  3. 177136-14147

FM Antenna

I have looked online for an answer to my question to no avail. I have a vintage receiver I want to hook up a 75 ohm coaxial antenna lead to. 

Picture of FM connection

I want to use the 75 ohm connection. I get putting the bare center wire under the screw. The clamp for the cable is what I have a question about. Do I remove the cable insulation to expose the ground mesh ? Do I leave the cable insulation on? 

Thanks

greywolf
stereo5's avatar
stereo5
6,363 posts
 

The braid must contact the clamp. The center wire goes to the screw above it.  No need for the adapter. 

ditusa's avatar
ditusa
1,879 posts
 

@stereo5, Is correct! No need for the adapter. 

greywolf OP
31 posts
 

I thought the braid needed to make contact with the clamp due to the fact the receiver hookup diagram shows the clamp going to ground. 

I don't want to use the 300 ohm adapter. I believe it causes signal loss.

Thanks

 

More to discover