2. cables
  3. 1299867359

Furutech spades on copper cables

I want to make DIY speaker cables.
I have Furutech copper-silver-copper-rhodium plated spades, that I'm planning to terminate copper multistrand wire with.
Speaker binding posts are WBT 0710 Ag (Silver).
My question is- would terminating copper wire with this particular connector, vs. the gold-plated one, be a problem?
Is there any rule of thumb with regards to matching cable material with the material used on speaker binding posts (Silver with silver, or copper with copper), or with the material, used on the cable connectors?
Thanks
maril555
zmanastronomy's avatar
zmanastronomy
738 posts
 
You shouldn't have any problems with mixing different metals on your termination.
Experiment until you find what you like.
Post removed 
mitch2
3,976 posts
 
Elizabeth says,
I have a hydralic crimper. not the worlds best, but what it crips stays crimped!
I second her use of the hydraulic crimper (like the one linked below) that I used on some pretty high quality speaker cables I assembled. Using stranded wire cables, the test crimp I tried almost appeared to be a continuous piece of metal between the spade and wire. Obviously not as good as the new machine Cardas has been using, but as good as I have seen from typical consumer crimping devices.

http://www.harborfreight.com/hydraulic-wire-crimping-tool-66150.html
More to discover