Only you can answer if it is worth all the expense. I know that once you get going in this hobby you can get really caught up in it, almost like being addicted. That being said, although I have never heard those speakers, I would look into getting either a power amp and pre amp or an intergrated amp. Also I believe that cables are very important, power cables, speaker cables and interconnects. What source are you using right now also would help other members with providing you with more suggestions, just my two cents, good luck
Getting the most of the sound out of my speakers?
I have sunfire ribbon speakers,the front two are CRS-3(80Hz-40kHz
Power Handling 25-440W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.) ,center CRW-3C(Frequency Response 80Hz-40kHz
Power Handling 25-440W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.) and two backs CRM-2BIPFrequency Response 80Hz-40kHz
Power Handling 25-400W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.), runing them all with DENON 3312 receiver ,I am new at high end settups meaning I do not know much about preamps,amps,processors...so the question I have is how can I improve my settup,what would work best with these speakers and the most important is it worth it going with this improvement considering the expense,thanks for any response
Power Handling 25-440W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.) ,center CRW-3C(Frequency Response 80Hz-40kHz
Power Handling 25-440W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.) and two backs CRM-2BIPFrequency Response 80Hz-40kHz
Power Handling 25-400W
Impedance 6ohm (nominal)
Sensitivity 90dB
SPL (max.), runing them all with DENON 3312 receiver ,I am new at high end settups meaning I do not know much about preamps,amps,processors...so the question I have is how can I improve my settup,what would work best with these speakers and the most important is it worth it going with this improvement considering the expense,thanks for any response
- ...
- 6 posts total
- 6 posts total