Goldmund Studio Power Supply Help

Hi Satch -

I do have the controller / power supply for the T3 arm & it's fine.

What I am missing is the power supply for the table.

That’s the power supply I need the specifications for.

Thanks for the other information though.

My Studietto runs on a DC 24 Volts/600 mA power supply. As far as I know, the motors on the Studietto and the Studio were similar, althuogh my Studietto has the newer JVC motor. The connection on the Studietto is some kind of screw-connection, so it might be tricky to find the fitting one. If youw want, I can send you a pic of that connection.

I think your Studio, not Studietto, had a more involved power supply than a wall wart for the table motor. If the Pabst motor goes bad the table is done! The arm motor may be simpiar, but it had an outboard controller. The arm was fussy about set up and will lift in the middle of the record. However they are great TTs. Connections/wiring may be tough. PH

I spoke to Helmut Brinkmann I believe we can help you. The Brinkmann LaGrange turntable uses a Pabst motor (http://www.brinkmann-audio.com/main.php?prod=lagrange〈=en). Thus, there are three possible power supply options I know of:
1. purchase a Brinkmann solid state power supply
2. purchase the Brinkmann tube regulated power supply
3. Buy my Tesserac regulated power supply designed for the Goldmund Studio. It works on my Brinkmann without modification. I forgot to include it when I sold the unit....duh
I own all three email me and perhaps we can work something out. If you simply wish the voltages email info@brinkmann-audio.com
Have a shiny day!