Has anyone heard the VPI Classic yet

Nolitan, I think your dealer's TT definitely has a problem as what's happening is not normal for the Classic. Mind you, I am using VPI peripheral ring clamp with upgrade center weight which also add significant weight to the platter as well and it always rotates pretty much right away everytime.

Nolitan...it sounds like your dealer needs to attach a transformer to the motor. Where are you located? Or your dealer can order a motor that is designed for your local electricity standard: 110-120V/60Hz (US standard) vs. 220-240V/50Hz (European/Asian standard).

Why doesn't the dealer contact VPI. The squeak is just the belt slipping for a split second. If the platter spins freely, than look at the motor. I too, use the ring and clamp with no issues. I have the speed controller and honestly can not tell the difference.

Thanks Guys!
I helped out the dealer.
I took out the belt and turned on the motor. Guess what, sometimes it spins, sometimes it doesn't spin.
However, if i turn the pulley, then the thing spins.
Same when the belt is attached to the platter, it needs to be kicked start by spinning the platter lightly & off it goes.
I think my dealer will contact vpi shortly.
What you guys think ? motor issues ?

Since this is the first unit Classic it arrived, were does one put the oil for fluid damping ? is it the one on top of the tonearm where there is a hole or is it the one were you remove the tonearm and near that sharp thingy ?

Thanks guys....

Nolitan:

I have an Aries 2, but perhaps I can help. Does the pulley on the motor (where you attach the belt) have a set screw? Have you attempted to tighten it with one of the Allen wrenches that came with the table? As far as damping fluid, it goes in the well at the base of the tonearm; to borrow your term, where the sharp thingy (pivot point) is. Fill it like 3/4 full.