Heavy Duty Binding posts for Krell KSA 250


Looking to find out if any folks out there have found and installed a more robust binding post for the older Krells, like the KSA 250. Hopefully without any modifications to the amp. The stock plastic post used on that amp does not really accommodate today's larger spaded speaker cables all that well. Any suggestions are appreciated!
badnixie2
Binding posts with screw-down installation on bare wire can't help being inferior. Just because it will be impossible to gain intimate contact with the wire. Soldering the tips of the wire strands will help but at the microscopic level, you will invariably confirm no contact at all, just arcing to greater or lesser degrees. You can tighten them with pliers and in a week they'll be so loose you can tighten further by hand. Zero consistency in listening tests. The ultimate post is no post at all. Hence, spades and bananas should be soldered to the wire while simultaneously being crimped. I use large channel lock pliers. Now since you do have intimate contact, I would dare wager you'd never hear the difference from one post to another.
Rrog, what specific model WBT posts did you try ? Did you properly crimp WBT copper sleeves to the ends of the wires with a WBT crimping tool before attaching the assembly to the posts with the set screws ? I have done a number of binding post upgrades to WBTs and never encountered loss of bass or other negative effects.
In the case of KSA-250/150, no soldering, set screws or wiring are used. The binding posts bolt directly to output "Buss" bars within the amplifier.

Not hard at all to change for any reasonable electronics technician, but not something I'd recommend to a non electronics person. Those KSA Series amps had very little if any bleeding of the power supply caps, even when unplugged for days these amps could knock you on your butt, or worse!
Gbart, you beat me to it! proper use of the WBT binding post type for set-screw to wire, should use the WBT crimp sleeves. I've used these and they work extremely well.
Response from the OP:

My..Mr. Rrog..arent we a condescending SOB! Maybe you should ask questions before making assumptions. But, oh, no that might be the prudent thing to do and if you did that you might not be able to justify your pompous rant. FYI. I did re-spade my EXISTING Cardas cables specifically for this amp, in other words, went to a smaller spade, Mr. smarty pants! If you had any experience with this amp whatsoever you would KNOW that the plastic stock posts are very basic and do not lend themselves well to some of today's heavy duty cables. But Cardas Golden Reference are amazing sounding speaker cables and I'm not about to give up on them! There may be some truth to what you say about the potential for the sound changing ( just doubtful how much and might it just be for the better) And as Mr. Rayooo says (BTW this gentlemen seems very knowledgeable about Krell amps as am I since I have had owned Krells since the late 80's) these are not difficult to change as long as you have some electromechanical expertise. Just so happens I do! The nice thing about these Krells is they have 2 sets of binding posts per channel and my plan is to change the top set and leave the bottom set in tact. And we'll just see what happens to the sound! If I don't like it, I'll go back to stock. Is that OK with you Mr Rrog?? Hmmm? Jeeesh!!