Helikon LOADING


Hi, I am really confused as to what is the right loading for this cartridge. The info that came with cartridge recommends 100 ohms to 47 K ohms. The inernal resistance is 5.5 ohms. This is quite a big range to decipher the 'correct' loading or 'equalization'(my analogy)and also tough to find the right phono that matches with unknown loading. I am auditioning few phonos at present and want to slect the right combination.

Also I want to have phono that is future proof, that is if I explore in multiple different cartridges, the phono amp is/will be compatible with these Carts. I read form past threads that general guideline is 25 times its internal impedance. How hard and fast this rule is?

So what is YOUR HELIKON LOADING? and how did you decide this value?

thx,

Nil
nilthepill
I seem to remember hearing that 530-580 ohms is recommended in most circumstances.
I am using a load of 100 ohms with excellent results. The tonal balance is rich and smooth without compromising the speed of transients and bass articulation.

The actual load is perference as well as system dependent. You should experiment with various load values.
I use 1k for both my Benz Ruby and my Helikon mono. Seems to work for both. I recall a review in Positive Feedback that also used 1k for the Helikon.

Randy
I am using an Audio Rearch PH-3 with my Helikon cartridge, and I have set the impedance at 100 ohms following a recommendation from one of the designers of the cartridge. Results are just fine!