Help Please With A Replacement For Old Aragon Amp.


There aren't any dealers allowing home auditions right now in my area so would appreciate some input n the following.
I think its time to upgrade from my old Aragon 8008BB power amp. It's been good to me but I've got the upgrade bug. Any suggestions as to a worthy replacement? I'm thinking no more than $1500-2000.  I've considered a Cambridge Audio Azur 841W or Musical Fidelity A3 cr power amp. Not opposed to going integrated.  Speakers are ATC Scm 19 V2
85db sensitivity but an ATC dealer told me they don't need gobs of power as often thought.  Pre amp right now is a First Sound Presence MK I (tubes)  The Aragon doesn't seem to grip the speakers despite it's power rating.  Thnks for any replies. 
zar
Have you checked the tubes in your preamp? After that, it may be time for the Aragon to be serviced. Your speakers are not so easy to drive and your Aragon doubles down on power into 4 Ohms, so a good match. Reviews of your speakers say they like amps with a lot of power. The MF A3 CR - maybe not a good fit. Another option at the top of your price range that may serve your needs is the Van Alstine Vision SET 400.
Thanks for your reply. My Aragon was serviced recently for a runaway bias issue.  I bought the pre amp from a friend I had bought a turntable from. He had it tuned up by First Sound. I spoke to Emmanuel Go of First Sound, and he suggested some further upgrades.  Wondering hard about that.  I have spoken to an ATC dealer and he suggested I change speaker cables. They're Cardas Clear Cygnus, well thought of and not cheap. He said any "average" 12 gauge speaker cable would suit the ATC speakers better as he stated Cardas cable "has a dark sound"  Any comments?  I tried to test his theory but my cables from my second system won't allow to me to try. The Z style banana plugs won't fit in the amps binding posts.
Your 8008 should have no problem gripping your speakers unless it’s being starved for juice then it can sound a little thin like any bigger amp can. Guessing you don’t have your system on a dedicated electrical circuit? If you don’t have a dedicated circuit, I would start there. Pull out the junk spec grade receptacles and at least go with a modest hospital grade outlet, and if you’re using the stock power cord get a 10 gauge cord. If you haven’t done any of these things with your 8008, it’s not its fault. Don’t change out your amp until you’ve tried this as the next amp will have the same issue likely.
Thanks adg, It's not on a dedicated circuit but I do have an Isotek Aquarius power component that is connected to the wall by an Audioquest Thunder cable with a 20 amp female receptacle. The Aragon is connected to one of the Isotek's  high current outlets with an Audioquest Tornado power cable.