2. speakers
  3. 1342557858

HELP with Vandersteen 2ci speakers

Need help with a set of Vandersteeen 2ci speakers. The issue I have is that to my ears I have to turn the voulme dial on my preamp to at least 9:30 or 10:00 to get any real volume out of them? Im not looking to blast them but I do like a nice amount of volume. I have to turn the volume to at least 7:00 to get anything above a very low whisper. I know they are somewhat hard to drive but im powering them with a set of Electron Kinetics Eagle 400 mono blocks which are putting out 350 watts each? Mono blocks have been serviced and tested and are up to snuff. Any help is greatly apreciated.

Thanks
artez
marakanetz's avatar
marakanetz
5,473 posts
 
If it sounds good to YOU it means that component is GOOD no matter what brand/model it is. Technically it has sufficient gain from your provided info. In my case I have almost the same situation. Normally I listen at 9:30...10 and crank it to 12...13:00 when I want it loud.
audioconnection
1,271 posts
 
Have you done the tiltback as in the manual with both
speakers equilly the same with a laser and bubble level?
artez OP
15 posts
 
no I haven't done the tilt back with the speakers. How do I adjust them to lean back?
adam18
670 posts
 
Proper tilt position with the Vandy's is crucial for the best possible sound, in order to maintain the time/phase alignment that Richard designs into the speakers. Go to the Vandersteen website and read the manual. Pay special attention to page 8. It's definitely worth the effort. Good Luck, and Happy Listening !

http://Vandersteen.com/2ce_signature_ii_manual.pdf
More to discover