Went to IKEA yesterday to check out the LACK end table and coffee table. The end table does have (now) hollow legs as indicated above. The coffee table, however, still has solid legs.
Here's How I Make My Equipment Racks
In response to a previous thread, here's how I make my
equipment racks:
List of equipment: 3/4" thick MDF cut to desired shelf
size
(4) 3/4" diameter 6' threaded steel rods
3/4" nuts and washers (8 per shelf)
Drill a 3/4" hole in the corner of each shelf in exactly the
same place. I do this by scribing a line with a square 1 1/2" inch in and using a nail set to punch a hole where the lines intersect. A drill press works great to drill the holes so they are all straight and true. Now that you have
a hole drilled in each corner of each shelf, simply screw
the whole thing together, adjusting each shelf to fit your
gear. Use a square to make sure your first shelf is straight, and measure each one likewise. If you do this
correctly, your rack will sit straight and level. If you
need to level it further, buy (4) 3/4 rod connectors, which
are about 3" high, and screw these into the bottom of the
rod and use them to level it. I paint the steel rod using
Krylon Industrial enamel (flat black looks best), and paint
the shelves to match your decor. This makes a very solid,
heavy audio rack. Total cost is about $40 for the steel
rod, $15 for the nuts and washers (about $1.00 a pound)
$20 for the MDF, and $5.00 worth of paint for a total under
$100. I've made several racks this way and have used the
same method to make CD racks.
Dave
equipment racks:
List of equipment: 3/4" thick MDF cut to desired shelf
size
(4) 3/4" diameter 6' threaded steel rods
3/4" nuts and washers (8 per shelf)
Drill a 3/4" hole in the corner of each shelf in exactly the
same place. I do this by scribing a line with a square 1 1/2" inch in and using a nail set to punch a hole where the lines intersect. A drill press works great to drill the holes so they are all straight and true. Now that you have
a hole drilled in each corner of each shelf, simply screw
the whole thing together, adjusting each shelf to fit your
gear. Use a square to make sure your first shelf is straight, and measure each one likewise. If you do this
correctly, your rack will sit straight and level. If you
need to level it further, buy (4) 3/4 rod connectors, which
are about 3" high, and screw these into the bottom of the
rod and use them to level it. I paint the steel rod using
Krylon Industrial enamel (flat black looks best), and paint
the shelves to match your decor. This makes a very solid,
heavy audio rack. Total cost is about $40 for the steel
rod, $15 for the nuts and washers (about $1.00 a pound)
$20 for the MDF, and $5.00 worth of paint for a total under
$100. I've made several racks this way and have used the
same method to make CD racks.
Dave
- ...
- 49 posts total
- 49 posts total