HiDiamond Power cords...

Calloway,
Yes, I mean changed. It is not difficult to do. You just need a good screwdriver with the right bit. The ends are soldered so they are stiff. Make sure you mark the ground when the wires are out. I only recommend changing these terminations if you are going to use the Oyaide M1 and F1. The less expensive Oyaides do not shine a light to them.

Ozzy,
Yes -- a very expensive upgrade. But worth every cent.

Soldered ends... very interesting. The M1 and F1's can be a little tricky if the cables are fat but otherwise it's easy.

Ozzy,

Can hi diamond put on a Neutrik powercon connector for the Audience conditioners? I have an ar12 and would be interested if they can do that.

Raks,
Yes, this is a little tricky. The M1/F1 are actually no different from other Oyaide models in this respect. The slots are all the same. You need to turn the screw to make the opening as wide as possible without disengaging the screw from the plate. Then you gently push each soldered end into each slot. A bit of nudging does it.