How do you change the battery in an ARC LS28 remote?

I've done searches on the Internet and have emailed ARC twice with no reply. The website says the faceplate is held on by magnets. There are no screws. How do I get in this remote? Thanks


The inset is really tight so no fingernails and I don't understand how dental floss could be of help? Using a magnet might work. I'm sure there is some simple proper way to open it up if I can just figure it out or hopefully someone on this forum might know and help me out.

Post removed 

Get a small suction cup and place on bottom of face plate on the logo. Then pull up.

Dental Floss

start in a corner, at the tight joint. pull dental floss in there. it is thin and damn strong.

leave it there, do  another corner, then another, make a gap, pry it off..

Watch the absolute sound fremer tour of the factory

Forward to the part about the remotes

You will see how the pop out the faceplate