How to make sound less detailed with warmth?


Hello All,

I am quite new to audio stuff... just been listening to my current set up for about a year.

CD Player: RCD-1072
Preamp: Sonic Frontier SFL-1
Poweramp: BK M-200 Sonata Series
Speaker: Thiel 1.3
Cable: Not sure...

I liked detailed sound at first but now I am more into musical and warm sound. It becomes a pain when I listen to violin on my current system. So my question is which part should I change to make my system sound more musical?

One more question: My BK M-200 Power amp just died on me. Is it a wise decision to send the unit back to B&K or get it fixed here?!?! Please let me know.

Thank you!
patch1980
Patch1980
I had the SFL-1 preamp connected to my system for a while a few years back. As you know the SFL-1 is a Hybrid. With a Sovtek or EH tube it will sound like a SS preamp. Change the tube to a NOS Mullard.... The preamp will sound like a tube preamp. Bet it will give you the sound you are looking for.

If memory serves me right the SFL-1 came new with two tubes. One Sovtek and one Mullard. I tried both and the Mullard won out hands down. [url=http://www.partsconnexion.com/]Email Chris Johnson[/url] and ask him which Mullard he would recommend.
If the Thiel 1.3 uses a metal dome tweeter then this may explain your problems with the violin - high Q resonance from a rigid diaphragm - it is a common problem with all light weight rigid diaphragms (ceramic, metal etc.).

Some designers (such as Audiophysic) use deep notch filters to try and eliminate this non-musical ringing, others (like Thiel) do not add notch filters because of the other phase issues they introduce, others (like accuton drivers) have rubber dampers on the cone itself, others use coatings instead of these visible rubber dampers, some have tried exotic shapes, some use a constrained layer approach (two rigid cones in a sandwich with a soft viscous fluid between the cones to dampen them).....all these efforts are to reduce the bell ringing from rigid light weight devices.

Why then do they use rigid light weight drivers? Becuase a rigid piston would be an ideal raditaing surface if it did not ring like a bell, and light weight drivers mean they can be coupled with small magnets and small motors and therefore are cheap to achieve a high level of efficiency.

This form of distortion can be particularly distracting and fatiguing because it is totally unreleated to the music. The more expensive the drivers the better this is controlled, however most speakers under $5,000 use drivers that cost the manufacturer around $50 wholesale... sound crazy....well it is even more crazy when you realize that the veneers and finishes are generally the most expensive cost of the speaker construction. Manufacturers know all to well that "how it looks" is often more important in sales than an extra 5% improvement in how it sounds. Audio furntiure is what audiophiles are mostly paying for. DIY'ers have known this for years....
There are plenty of people who have tame their Thiels. I agreed, it is way easier to get rid of the them than dealing with all the work and money to get them to sing. But isn't that what audiophiles do anyway, regardless if they own Thiels or not, spend time and money on their rigs?

I ageed wtih the above post, since you are replacing your amp anyway, start with that before selling the Thiels. Room treatment is a must, regardless what speakers you are running. As far as replacing cables, I like Harmonic Tech cables with Thiels.

Anyway, here are a few things you can do before upgrading any of your components.

/ dedicated lines
/ room treatment
/ good audio rack

These few things will make any system better.
Good Luck!
Tubemiser is spot on. 1)Room treatment 2)Clean up your AC 3)Vibration control (a good rack and various feet to choose from).