How to select a good Speaker Cable


Speaker cables do have a significant role in how our system sounds. Different cables sound different. 

So which one is the right one for you?

The Speaker Cable is an extension of the Amp. and not an addition to the speaker's load. It shall have a certain resistance (low) not to spoil the Amp's DF figure. As so, it can be calculated and there is a formula to do it.

The higher the Amp's DF, the lower the Speaker Cable's resistance shall be. As today SS power Amp's get DFs of 400 and above (Digital Amps go by thousands) the cable of 10 ft (3m) long, gets as thick as 0 AWG.

I can see your eyebrows elevates, when that thick cable is to be deal with. Most Speaker Cable makers skip it because of that. So most cables on the market (regardless of the look or price) are of 14-12 AWG. Way less that supposed to be.

Worst! no Speaker Cable maker, dealer or seller knows the answer, of what is the correct cable for your system. 

So most of us ended up, with a cables too thin for the task.

A conducted test, on this site, about a year ago as well as with some closer friends, shows a significant improvement with a calculated size cable over their previous cable. The results were all positive and preferred the calculated cable.

So, instead of asking: which of two brands, or two prices or two colors of Speaker Cable do I need, you should ask how thick of a Speaker Cable do I need.

I'll be happy to provide you the calculation, for who request it. All you need to provide is:

1). Length (Ft. or meter)

2). The Amp's DF figure.

Thanks


128x128b4icu
Hi,

My speaker cables are 3meters long and the DM is 320 (Luxmam 590AX Markll 

Many thanks
Peter 
Mr. kiwipeter

For 3 m and DF = 320, a #1 awg is recommended (you can go also with #0 awg).
b4icu,

Glad to see are you are well and offering useful free advice.

You may recall I used your DIY 0 AWG cable (relatively flexible thin strand welder's cable) to connect Pass Lab 250.5 to Magnepan MGIIIa's.  Fantastic results.

I have changed the amp to a Devialet 120 Class D integrated.  It loves you cables.  My simplistic system consists of an Auralic Aries connected to the 120, driving the Maggies.  In addition, I use the pre-out/electronic crossover to connect a 12" Velodyne FSX.  The room is 35x25x14ft.  All electronics are power by a Yeti 1000 drawing less than 50 watts.

I noted that you referenced Class D amplification above.  Would you be so kind as to share your information as to why your designs work so well with Class D amps.  I am assuming that you have not already addressed this issue.  I have not read all of the posts on this thread.

Best Regards,

J