2. analog
  3. 1268458162

Hum from Grado on LP12.. Better carts to consider?

I've had a problem with hum on my LP12 for as long as I can remember. The table (bought used) came with a Grado Signature 8MZ and I've since tried a Grado Z+ that I had from another table. Both have the same amount of hum. I have a lot of RF and noisy AC in my house. The hum is noticeable when I switch to phono and gets louder as I move the cart over the rim of the platter. From there it decreases as I move the arm towards the spindle. (The table is 80's vintage with Ittok and Circus/Lingo upgrades).

A (non-Linn) dealer said 'oh Grados do that on LP12s - lack of shielding'. My Linn dealer didn't nave a strong opinion. He suggested a Benz Ace H given my under- $700 budget. From reading the Agon forums, some think an AT150 M series has better sound for less $. I've also heard good things about the Dynavector DV-20X. Does MM/MI vs. HOMC matter in terms of hum or is the degree of 'shielding' a variable from cartridge to cartridge no matter which type? Does a good review on a MC necessarily extend to the HO version, as opposed to the LO/MO versions?

My system: ARC PH1 (48 dB gain, variable loading via soldering iron)
ARC LS2BII
PSE Studio IV/V's
Audio Physic Tempo III's
FWIW: Meridian 508 CD player is dead quiet in this system.

Music: from Joni Mitchell to Ian Dury and the Blockheads, Monk to Mozart.

Thanks for any knowledge you can impart!
geor
sarcher30
596 posts
 
An outboard power supply like a Lingo would most likely solve the problem.

One way to find out is to unplug your Linn, swing the tonearm over the platter, and see if it still hums. If it does then it's the power supply in the deck. You have to unplug because the power supply stays energized even when not spinning.

Sean
sarcher30
596 posts
 
Whoops, meant to say if it does not hum when it's unplugged then it's the power supply.
geor OP
37 posts
 
Thanks Sean. I do have the Lingo. I've only had two cartridges on this 'table (both Grado), so maybe it's time to live dangerously and try something new ;-)
sarcher30
596 posts
 
Sorry, I missed that you have a Lingo.

I think that a cart with a metal body would be less prone to hum.

Sean

geor OP
37 posts
 
After doing much research on Audiogon and the web in general, I am beginning to realize the problem is a ground loop hum. I have a rooftop FM antenna that is grounded to a single rebar spike. This apparently is not a good setup - too much resistance. It should be two copper clad steel rods, 5/8" x 8' long, 8' apart driven below grade, with the two ground rods connected via buried heavy gage stranded copper wire. The loop is formed by the potential difference between the ground of the FM coax (steel rod) and that of the main electrical service panel (water pipe). It seems that I should also add two ground stakes outside the main panel and connect all ground stakes with the heavy buried copper wire.
Off to the electrical supply store and not the needle shop!
More to discover