@slaw , that is very good to hear, that good results can be had with the noted discrepancy in the pivot to spindle distance not being as advertised. The issues with both my tables is that the stated spindle to pivot distance is one mm short. Was wondering where yours was when you sent it back to VPI to have them send it back one mm long?
I finally get it!
I had a long discourse with VPI after I bought my new Classic 3 Sig SE years ago. The subject was that the S2P distance was off. After over one year of trying to get this resolved, I still received my tt back with this distance 1 mm (long).
I always wondered why there was no forthcoming measurement of the S2P distance. After all, VPI is know to have customers DIY their own tts, based on VPI's own products.
So, VPI offers their set-up jig with new tts. They don't offer any specific measurements for S2P. Someone had to ask on their forums in order to find out. Why?
I now know why. Because, their manufacturing was/is not very precise. So, if their S2P distance was off when the tt left their shop, their own jig (provided) would still keep the S2P distance in a (good enough) range.
Nice try/trick.
I always wondered why there was no forthcoming measurement of the S2P distance. After all, VPI is know to have customers DIY their own tts, based on VPI's own products.
So, VPI offers their set-up jig with new tts. They don't offer any specific measurements for S2P. Someone had to ask on their forums in order to find out. Why?
I now know why. Because, their manufacturing was/is not very precise. So, if their S2P distance was off when the tt left their shop, their own jig (provided) would still keep the S2P distance in a (good enough) range.
Nice try/trick.
- ...
- 34 posts total
- 34 posts total