2. amps-preamps
  3. 1377353058

impedance question and tubes

My speakers have a nominal impedance of 6 ohms and range from a high of 11 ohms to a low of 4.5 ohms. My tube amp has both 4 ohm and 8 ohm taps. What does conventional wisdom say about which taps to use. I have found listening to be confusing: with the factory tubes in the amp the system sounded better on the 8 ohm taps: more balanced; the 4 ohm tap was bass heave. BUT, with some nice NOS tubes in the amp which opened up the top end I now seem to get a fuller and more complete sound on the 4 ohm taps. Is it fine to let my ears drive the decision? Also, theoretically, should one set of taps be louder than the others? Thanks for your help.
dgaylin
dgaylin OP
255 posts
 
Thanks Roscoe.

This amp has a lot of power (Copeland 506). 90 watts per channel. Speakers are not the easiest load at 87db. But it is plenty loud with out any apparent lack of reserves.
atmasphere's avatar
atmasphere
11,810 posts
 
Since speakers often do not have linear impedance curves, you do often have to try other impedance taps to see which offers the best performance.

'Light loading' can be good for the power tubes but can also introduce more harmonic distortion, which will be interpreted by the ear as 'richness'. This is because if the output transformer is not loaded down enough, it can ring (distort although not due to saturation). So there can be tradeoffs as any extra distortion will obscure some low level detail.
dgaylin OP
255 posts
 
Thanks Atmasphere, this is very interesting. I will listen again with some of this in mind. Very helpful!
More to discover