So many DDCs, so little time. BTW, and if u don’t mind me asking, what’s the rest of the equipment, cables, etc. in ur system?
Interesting video on cables
At the risk of opening up this can of worms again, my brother sent me this video. It’s incredibly interesting and goes some way to showing why cables matter and that all cables are not equal. These are USB cables but I’m sure the principle applies to speaker and IC cabling.
- ...
- 34 posts total
Jastralfu, As Soix mentioned, I've been in a similar situation. I however am using a BlueSound Node 130, instead of a computer based streamer. You've already come to the conclusion that you need a better streamer, and there are plenty from the Innuous/Aurender/Lumin usual suspects...as well as others. Adding a DDC will definitely (IMO) improve the quality of your streaming, but at what point does the computer based streaming become the limiting factor? I bought the Iris DDC which upgrades the clock from the FEMTO clock in the Pontus II to a temperature controlled (TXCO) unit in the Iris (like the Venus DAC).....the Hermes and Gaia up the ante further to an oven controlled unit (OCXO) like that in the Terminator series. It also allows the ability to use I2S as the primary connection, from the Iris/Gaia/Hernes to the Pontus. The reason why that is important, and worth reading up on, is that digital sources use I2S serial bus internally as their native way of communicating amongst themselves. Using an I2S connection from the Iris eliminates the conversion from I2S, to SPDIF/USB/??? and then back again to I2S in the Pontus. Electrical engineers please don't blast me here, I know it's a simplistic explanation. Now that is getting somewhere! As Soix pointed out adding the Iris between the Node 130 and Pontus (and using a good high speed I2S cable between the two), was a complete game changer. Every single sound quality was improved, and not by a small amount....it was like I had installed a brand new high quality streamer, with much better specs. Now I am not sure which made the most difference, adding the DDC between the two or changing to I2S? I suspect both equally.....though I've done no testing on that theory as I made the changes simultaneously. Here is my dilemma (and maybe yours I suspect), "when I upgrade my streamer, will I even need/use a DDC?" That is something I don't know the answer to, even though I have tested both an Aurender N10 and N200 in my system.....I did not have the Iris at the time.....to do a comparison. For me it would be much easier to buy and sell an Iris and lose a couple hundred dollars, versus the Hermes or Gaia where I could lose a bunch more....or buy used as Soix suggested. I think it would be worth your time to send an email to Alvin Chee at Vinshine Audio (the distributor for Denafrips products), who I think would give you an honest recommendation and answer any questions you may have sales@vinshineaudio.com He has been very responsive to any and all questions I have had for him. |
Thumbs UP for any Denafrips DAC. The video makes a few points all participating in the Audio Hobby should take seriously. A general message is that technical knowledge does not make one a subject matter expert for all things. Clearly the two cables in question perform very different functions requiring very different design and manufacturing skill sets. Points made in the video about wire being an antenna and EMI/RFI present in our environment are facts that cannot be brushed aside. Do not assume that expensive cables are required in every situation. Do understand that properly designed cable for the intended environment and function is required. Do understand that those claiming L, C, and R measurements completely characterize all cable are wrong. |
- 34 posts total